Ean 8 Label Id - Datalogic Magellan 8300 Product Reference Manual

EAN 8 Label ID

NOTE
Product Reference Guide
This feature specifies an EAN 8 label ID to be added to bar code
data.
To set this feature:
The programming feature, Label ID Control, designates whether the
Label ID is transmitted as a prefix or suffix or if Label ID is disabled.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code, SET EAN 8 LABEL ID on page 295 below.
You'll need to cover any unused bar codes on this and the fac-
ing page to ensure the scanner reads only the bar code you
intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C
that represent the desired Label ID characters; entered as two
hex pairs. A table containing the ASCII Character Set on page 1
and their corresponding Hex Values is available in the inside
back cover of this manual. ASCII parameters must be input by
scanning a pair of hexadecimal digits for each character. Thus,
to set a two-character value of AB, bar codes containing the
digits '4', '1', '4', and '2' must be scanned. The selectable
range for this option is any hex value from 00 to FF.
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET EAN 8 LABEL ID
EAN-8 Enable
295