Ack Nak Enable - Datalogic Magellan 8300 Product Reference Manual

Hide thumbs Also See for Magellan 8300:

Table of Contents

RS-232 ACK NAK Enable

This enables/disables the ability of the scanner to support the RS-

232 ACK/NAK protocol. When configured, the scanner and/or host

sends an "ACK" when it receives data properly, and sends "NAK"

when the data is in error. Selections for this option are:

Label Transmission — the scanner expects an ACK/NAK

response from the host when a label is sent)

Host Acknowledgement — Enabled for Host Commands (the

scanner will respond with ACK/NAK when the host sends a

Label & Host — Enabled for both Label Transmission & Host

To select the option for RS-232 ACK NAK Enable:

1. Scan the SWITCH bar code.

2. Scan the desired option from bar codes below and on the fol-

lowing page. You'll need to cover any unused bar codes on

this and the facing page to ensure that the scanner reads only

the bar code you intend to scan.

3. Complete the programming sequence by scanning the SWITCH

RS-232 ACK/NAK = LABEL TRANSMISSION

RS-232 ACK NAK = DISABLE

Magellan™ 8300/8400

Magellan 8400