Keyboard Interface - Keyboard Simulation - Datalogic Magellan 8300 Product Reference Manual

Keyboard Interface — Keyboard Simulation
NOTE
Product Reference Guide
Enables/disables ability of scanner to perform host communications
normally performed by attached keyboard.
This feature does not apply to the USB Keyboard interface.
All PCs check the keyboard status during the power-on Selftest. It is
recommended that you enable this function if you are working with-
out a keyboard installation. It simulates keyboard timing and passes
the keyboard status to the PC during power-on.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You'll need
to cover any unused bar codes on this and the facing page to
ensure that the scanner reads only the bar code you intend to
scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
Keyboard Wedge/USB Keyboard Features
KEYBOARD SIMULATION = DISABLE
KEYBOARD SIMULATION = ENABLE
249