Number Of Stop Bits - Datalogic Magellan 8300 Product Reference Manual

Hide thumbs Also See for Magellan 8300:

Table of Contents

RS-232 Number of Stop Bits

Specifies number of stop bits required for sending and receiving

8 data bits with 2 stop bits and parity enabled is not a valid configura-

To set this feature:

1. Scan the SWITCH bar code.

2. Scan the bar code below representing the desired Stop Bit set-

ting. You'll need to cover any unused bar codes on this and

the facing page to ensure that the scanner reads only the bar

code you intend to scan.

3. Complete the programming sequence by scanning the SWITCH

RS-232 NUMBER OF STOP BITS = 1

RS-232 NUMBER OF STOP BITS = 2

Magellan™ 8300/8400

Magellan 8400