128 Supplemental Label Id - Datalogic Magellan 8300 Product Reference Manual

EAN-8 128 Supplemental Label ID
NOTE
298
This feature specifies an EAN-8 128 Supplemental label ID to be
added to bar code data.
The programming feature, Label ID Control, designates whether the
Label ID is transmitted as a prefix or suffix or if Label ID is disabled.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code, SET EAN-8 128 SUPPLEMENTAL LABEL ID on
page 298 below. You'll need to cover any unused bar codes on
this and the facing page to ensure the scanner reads only the
bar code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C
that represent the desired Label ID characters; entered as two
hex pairs. A table containing the ASCII Character Set on page 1
and their corresponding Hex Values is available in the inside
back cover of this manual. ASCII parameters must be input by
scanning a pair of hexadecimal digits for each character. Thus,
to set a two-character value of AB, bar codes containing the
digits '4', '1', '4', and '2' must be scanned. The selectable
range for this option is any hex value from 00 to FF.
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET EAN-8 128 SUPPLEMENTAL LABEL ID
Magellan™ 8300/8400