Advertisement
Warning:
For a safe and reliable installation, use only
the accessories and screws provided with the device. Use
of other accessories and screws could result in damage to
the unit. Any damages incurred by using unapproved
accessories are not covered by the warranty.
Avertissement:
Pour une installation sûre et fiable,
utilisez uniquement les accessoires et les vis fournies avec
l'appareil. L'utilisation d'autres accessoires et vis pourrait
endommager l'appareil. Les dommages causés par
l'utilisation d'accessoires non approuvés ne sont pas
couverts par la garantie.
Note:
The drawings in this document are for illustration only
and may not match your particular model.
Mount the Device
1
1. Attach the Brackets
Use the included flathead M4x8 screws to attach the brackets.
2. Mount the Device
Mount the device in the rack and secure it with rack screws.
Note:
The device can also be installed on a desktop or
shelf using the included adhesive rubber feet.
2
Ground the Device
Attach a lug (not provided) to a #18 AWG minimum grounding wire
(not provided), and connect it to the grounding point on the rear panel.
Then connect the other end of the wire to rack ground.
Installation
3
Connect Power
Connect an AC power source to the device.
4
Make Network Connections
RJ-45 PoE Ports
Connect Cat. 5e or better twisted-pair cable.
SFP Ports
Install transceivers and then connect fiber optic cabling to the
transceiver ports. The following transceivers are supported:
1000BASE-SX/LX and 1000BASE-T (RJ-45)
100BASE-BX
5
Connect to the Web User Interface
1.
Connect a PC directly to one of the switch's RJ-45 ports.
2.
Set the PC IP address to be on the same subnet as the switch (that is,
the PC and switch IP addresses must both start 192.168.2.x with
subnet mask 255.255.255.0).
3.
Enter the switch's default management IP address of 192.168.2.10
into the web browser address bar.
4.
Log in to the web interface using the default settings:
User Name = admin
Password = admin
Note:
For more information on switch configuration using
the web interface, refer to the Management Guide, which is
on the Edgecore web site, wifi.edge-core.com.
– 2 –
Quick Start Guide
Advertisement
