Ip Dhcp Restart Client - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

ip dhcp restart client

The server should reply with Option 66 attributes, including the TFTP

server name and boot file name.

Note that the vendor class identifier can be formatted in either text or

hexadecimal using the ip dhcp client class-id command, but the

format used by both the client and server must be the same.

Console(config)#interface vlan 2

Console(config-if)#ip dhcp client class-id hex 0000e8666572

Console(config-if)#

ip dhcp restart client (1363)

This command submits a BOOTP or DHCP client request.

Privileged Exec

This command issues a BOOTP or DHCP client request for any IP

interface that has been set to BOOTP or DHCP mode through the

DHCP requires the server to reassign the client's last address if

If the BOOTP or DHCP server has been moved to a different domain,

the network portion of the address provided to the client will be based

on this new domain.

In the following example, the device is reassigned the same address.

Console(config)#interface vlan 1

Console(config-if)#ip address dhcp

Console(config-if)#exit

Console#ip dhcp restart client

Console#show ip interface

VLAN 1 is Administrative Up - Link Up

Address is 12-34-12-34-12-34

Index: 1001, MTU: 1500

Address Mode is DHCP

IP Address: 192.168.0.9 Mask: 255.255.255.0

| DHCP Commands

Table of Contents