Creating And Deleting A Receiver Port; Creating A Receiver Port In An Ipmvlan; Deleting A Receiver Port From An Ipmvlan; Associating An Ipmvlan With A Customer Vlan - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring IPMVLAN

Creating and Deleting a Receiver Port

The following subsections describe how to create and delete a receiver port in an IPMVLAN with the
vlan ipmvlan receiver-port

Creating a Receiver Port in an IPMVLAN

To create a receiver port in an IPMVLAN configured in the Enterprise mode, use the
vlan ipmvlan receiver-port
-> vlan ipmvlan 1003 receiver-port port 1/51
In the VLAN Stacking mode, the port that you want to configure as a receiver port should be a VLAN
Stacking User Network Interface (UNI). To create a receiver port in an IPMVLAN configured in the
VLAN Stacking mode, use the VLAN Stacking ethernet-service command and the vlan ipmvlan
receiver-port command, as shown below:
-> ethernet-service ipmvlan 1003
-> vlan ipmvlan 1003 receiver-port port 1/49
Note that in the above example, port 1/49 was previously configured as a VLAN Stacking UNI. For more
information about how to configure a UNI, see

Deleting a Receiver Port from an IPMVLAN

To delete a receiver port from an IPMVLAN in the Enterprise or VLAN Stacking mode, use the no form
of the vlan ipmvlan receiver-port
ID, the keyword receiver-port, and the port number, as shown below:
-> no vlan ipmvlan 1003 receiver-port port 1/51

Associating an IPMVLAN with a Customer VLAN

To associate an IPMVLAN with a customer VLAN (CVLAN), use the
that configuring a customer VLAN tag for an IPMVLAN is not supported in the Enterprise mode. For
example, the ethernet-service
vlan ipmvlan ctag command configures the CVLAN tag for the IPMVLAN:
-> ethernet-service ipmvlan 1002
-> vlan ipmvlan 1002 ctag 10
For more information about configuring IPMVLANs in VLAN Stacking mode, see
ing VLAN Stacking."
page 43-12
command.
command as shown below:
Chapter 9, "Configuring VLAN Stacking."
command by entering no vlan ipmvlan followed by the IPMVLAN
VLAN Stacking command is used to create the IPMVLAN and then the
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring IP Multicast VLAN
vlan ipmvlan ctag command. Note
Chapter 9, "Configur-
September 2009