Table 184: Show Fault-Notify-Generator - Display Description - Edge-Core ECS4510-28P User Manual

| CFM Commands
C 45
HAPTER
Delay Measure Operations
Delay Measure Operations
ethernet cfm delay-
measure two-way

Table 184: show fault-notify-generator - display description

Field Description
MD Name The maintenance domain for this entry.
MA Name The maintenance association for this entry.
Hihest Defect The highest defect that will generate a fault alarm. (This is disabled
by default.)
Lowest Alarm The lowest defect that will generate a fault alarm (see the
notify lowest-priority
Alarm Time The time a defect must exist before a fault alarm is issued (see the
mep fault-notify
Reset Time The time after a fault alarm has been issued, and no defect exists,
before another fault alarm can be issued (see the
reset-time
This command sends periodic delay-measure requests to a specified MEP
within a maintenance association.
S
YNTAX
ethernet cfm delay-measure two-way [src-mep source-mpid]
{dest-mep destination-mpid | mac-address} md domain-name
ma ma-name [count transmit-count] [interval interval]
[size packet-size] [timeout timeout]
source-mpid – The identifier of a source MEP that will send the
delay-measure message. (Range: 1-8191)
destination-mpid – The identifier of a remote MEP that is the target
of the delay-measure message. (Range: 1-8191)
mac-address – MAC address of a remote MEP that is the target of
the delay-measure message. This address can be entered in either
of the following formats: xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – Maintenance association name. (Range: 1-43
alphanumeric characters)
count – The number of times to retry sending the message if no
response is received before the specified timeout. (Range: 1-5)
interval – The transmission delay between delay-measure
messages. (Range: 1-5 seconds)
packet-size – The size of the delay-measure message.
(Range: 64-1518 bytes)
timeout - The timeout to wait for a response. (Range: 1-5 seconds)
D S
EFAULT ETTING
Count: 5
Interval: 1 second
– 1332 –
command).
alarm-time, command).
command).
mep fault-
mep fault-notify