Configuring A Standard Ipv4 Acl - Edge-Core ECS4110-28T Management Manual

C
ONFIGURING A
S IP 4 ACL
TANDARD V
Figure 190: Showing a List of ACLs
Use the Security > ACL (Configure ACL - Add Rule - IP Standard) page to
configure a Standard IPv4 ACL.
CLI R
EFERENCES
"permit, deny (Standard IP ACL)" on page 971
◆
"show ip access-list" on page 976
◆
"Time Range" on page 782
◆
P
ARAMETERS
These parameters are displayed:
◆ Type – Selects the type of ACLs to show in the Name list.
Name – Shows the names of ACLs matching the selected type.
◆
Action – An ACL can contain any combination of rules which permit or
◆
deny a packet.
Address Type – Specifies the source IP address. Use "Any" to include
◆
all possible addresses, "Host" to specify a specific host address in the
Address field, or "IP" to specify a range of addresses with the Address
and Subnet Mask fields. (Options: Any, Host, IP; Default: Any)
Source IP Address – Source IP address.
◆
Source Subnet Mask – A subnet mask containing four integers from 0
◆
to 255, each separated by a period. The mask uses 1 bits to indicate
"match" and 0 bits to indicate "ignore." The mask is bitwise ANDed with
the specified source IP address, and compared with the address for
each IP packet entering the port(s) to which this ACL has been
assigned.
Time Range – Name of a time range.
◆
– 359 –
| Security Measures
C 13
HAPTER
Access Control Lists