Configuring Interface Settings For Web Authentication - Edge-Core ECS4110-28T Management Manual

| Security Measures
C 13
HAPTER
Web Authentication
C
ONFIGURING
I S
NTERFACE ETTINGS
W
FOR EB
A
UTHENTICATION
Figure 169: Configuring Global Settings for Web Authentication
Use the Security > Web Authentication (Configure Interface) page to
enable web authentication on a port, and display information for any
connected hosts.
CLI R
EFERENCES
"Web Authentication" on page 909
◆
P
ARAMETERS
These parameters are displayed:
Port – Indicates the port being configured.
◆
Status – Configures the web authentication status for the port.
◆
Host IP Address – Indicates the IP address of each connected host.
◆
Remaining Session Time – Indicates the remaining time until the
◆
current authorization session for the host expires.
◆ Apply – Enables web authentication if the Status box is checked.
Revert – Restores the previous configuration settings.
◆
Re-authenticate – Ends all authenticated web sessions for selected
◆
host IP addresses in the Authenticated Host List, and forces the users
to re-authenticate.
W I
EB NTERFACE
To enable web authentication for a port:
Click Security, Web Authentication.
1.
Select Configure Interface from the Step list.
2.
Set the status box to enabled for any port that requires web
3.
authentication, and click Apply
– 330 –