Cluster Member
Use the Administration > Cluster (Configure Member - Add) page to add Candidate
switches to the cluster as Members.
Configuration
Parameters
These parameters are displayed:
◆
◆
Web Interface
To configure cluster members:
1.
2.
3.
4.
5.
Figure 272: Configuring a Cluster Members
To show the cluster members:
1.
2.
3.
Member ID – Specify a Member ID number for the selected Candidate switch.
(Range: 1-36)
MAC Address – Select a discovered switch MAC address from the Candidate
Table, or enter a specific MAC address of a known switch.
Click Administration, Cluster.
Select Configure Member from the Step list.
Select Add from the Action list.
Select one of the cluster candidates discovered by this switch, or enter the MAC
address of a candidate.
Click Apply.
Click Administration, Cluster.
Select Configure Member from the Step list.
Select Show from the Action list.
– 415 –
Chapter 13
| Basic Administration Protocols
Switch Clustering