show time-range
Switch Clustering
This command shows configured time ranges.
Syntax
show time-range [name]
name - Name of the time range. (Range: 1-32 characters)
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show time-range r&d
Time-range r&d:
absolute start 01:01 01 April 2009
periodic
Daily 01:01 to
periodic
Daily 02:01 to
Console#
Switch Clustering is a method of grouping switches together to enable centralized
management through a single unit. Switches that support clustering can be
grouped together regardless of physical location or switch type, as long as they are
connected to the same local network.
Table 28: Switch Cluster Commands
Command
cluster
cluster commander
cluster ip-pool
cluster member
rcommand
show cluster
show cluster members
show cluster candidates
Using Switch Clustering
◆
A switch cluster has a primary unit called the "Commander" which is used to
manage all other "Member" switches in the cluster. The management station
can use either Telnet or the web interface to communicate directly with the
Chapter 4
Daily 02:01
Daily 03:01
Function
Configures clustering on the switch
Configures the switch as a cluster Commander
Sets the cluster IP address pool for Members
Sets Candidate switches as cluster members
Provides configuration access to Member switches
Displays the switch clustering status
Displays current cluster Members
Displays current cluster Candidates in the network
– 171 –
| System Management Commands
Switch Clustering
Mode
GC
GC
GC
GC
PE
PE
PE
PE