Cluster Member - Edge-Core ECS4210-12P Reference Manual

Command Mode
Global Configuration
Command Usage
◆
◆
◆
Example
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#

cluster member

This command configures a Candidate switch as a cluster Member. Use the no form
to remove a Member switch from the cluster.
Syntax
Default Setting
No Members
Command Mode
Global Configuration
Command Usage
◆
◆
Example
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
An "internal" IP address pool is used to assign IP addresses to Member switches
in the cluster. Internal cluster IP addresses are in the form 10.x.x.member-ID.
Only the base IP address of the pool needs to be set since Member IDs can only
be between 1 and 36.
Set a Cluster IP Pool that does not conflict with addresses in the network IP
subnet. Cluster IP addresses are assigned to switches when they become
Members and are used for communication between Member switches and the
Commander.
You cannot change the cluster IP pool when the switch is currently in
Commander mode. Commander mode must first be disabled.
cluster member mac-address mac-address id member-id
no cluster member id member-id
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch. (Range: 1-36)
The maximum number of cluster Members is 36.
The maximum number of cluster Candidates is 100.
– 147 –
Chapter 4
| System Management Commands
Switch Clustering