Disassembly Of Propeller Shaft Ass'y - TOHATSU MD 70-90C2 Service Manual

Lower Unit
15) Disassembly of Propeller Shaft
Ass'y
Remove push rod 1 and steel balls 2 (3 pcs.).
1.
Put a bladed screw driver into one of clutch pin snap 3
2.
end, and take the snap out from the clutch groove while
winding it.
Pull out clutch pin 4, and remove clutch spring retainer
3.
5, clutch spring 6, and clutch by referring to the figure.
· When removing
protective glasses, and do not point
opening of propeller shaft to your face or
body while holding the propeller shaft.
Clutch pin or spring holder may fly out
very quickly.
· Install push rod 1, and pull out pin 4
while pushing propeller shaft onto a plane
to prevent retainer 5 and spring 6 from
flying out.
After taking out clutch spring retainer 5 and clutch spring
4.
6, remove clutch 7 from propeller shaft.
6-20
WARNING
clutch pin, wear
3
7
6
5
2
1
4
3 Clutch Pin Snap
Do not reuse.
3 Clutch Pin Snap
Do not reuse.
7
3
4
1
TLDI 75/90C2 2010