Delete Link_Aggregation; Config Link_Aggregation - D-Link DGS-3100 SERIES Cli Manual

delete link_aggregation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete link aggregation group:

config link_aggregation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1 with group members ports 5-7 plus port 9:
Success.
DGS3100#
To delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-32>
The delete link_aggregation group_id command deletes a
previously configured link aggregation group.
group_id <value 1-32> − Specifies the group ID. The Switch allows
up to 32 link aggregation groups to be configured. The group
number identifies each of the groups.
Only administrator or operator-level users can issue this command.
DGS3100# delete link_aggregation group_id 1
Success.
DGS3100#
To configure a previously created link aggregation group.
config link_aggregation group_id <value 1-32> { ports <portlist>
| state [enable | disable] }
The config
aggregation group created with the create link_aggregation
command above.
group_id <value 1-32> − Specifies the group ID. The Switch allows
up to 32 link aggregation groups to be configured. The group
number identifies each of the groups.
ports <portlist> − Specifies a list of ports to belong to the link
aggregation group. Ports will be listed in only one aggregation group
and link aggregation groups can not overlap to each other. The user
must cofigure at list two ports in LAG.
state [enable | disable] − Enables or disables the specified link
aggregation group.
Only administrator or operator-level users can issue this command.
Link aggregation groups may not overlap.
DGS3100# config link_aggregation group_id 1 ports 5-7,9
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
link_aggregation command configures a link
110