Adjust（Adjustment Mode; Copier - Canon imageRUNNER 2270 Service Manual

Chapter 16
16.4 ADJUST（Adjustment Mode）

16.4.1 COPIER

16.4.1.1 Copier List
<AE>
Sub-item
AE-TBL Adjusting the character density at image density adjustment
<Setting range> 1 to 9 (Default: 5)
Setting a greater value makes characters darker.
Setting a smaller value makes characters lighter.
If RAM on the reader controller circuit board has been cleared, enter the value from
the service label.
<ADJ-XY>
Sub-item
Adjusting the mage read start position
- If RAM on the reader controller circuit board has been cleared or the board itself has been replaced, enter the
value from the service label.
- If the setting of this item has been changed, enter the new value into the service label.
ADJ-X Adjusting the optical image head position (image read start position in the
subscan direction)
<Setting range> 1 to 100 (Default: 20)
Increasing the value by 1 shifts the image read start position 0.1 mm backward.
16-40
T-16-16
COPIER > ADJUST > AE
Description
T-16-17
COPIER > ADJUST > ADJ-XY
Description
0007-9190
Level
1
Level
1