If The System Will Not Set - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300
alarm system meets the
appropriate standards.
In addition, the installer may have
programmed the system to briefly flash the
strobe light on the external sounder when
the system sets.
Changing Your Mind
If the system has not yet set and
you want to stop setting then
either press
press the  key.

If the System Will Not Set

Normally, the system will set only when all the detectors are "quiet", that is:
not reporting any activity.
If you have the final exit door open, or if you trigger one of the detectors on
your exit/entry route, then the keypad and internal sounder will give an
interrupted setting tone (this is normal). Make sure that you close all the
doors on your exit route and the final exit door as you leave. The
interrupted tone will change to a continuous exit tone, and the system will
set normally.
If you try to set when one or more detectors are still active then the bottom
line of the display tells you which zone is active, for example the back door
- see Figure 6.
(unset key) or
3. Setting and Unsetting
Page 27