Programming Outputs - Eaton i-on16 Administrator's And User Manual

4. Administration
Press .
9.
The top line of the display shows "Set
the Time" and the bottom line of the
display shows the current system time.
The minutes are highlighted.
10. Key in the correct time. Use the 24-
hour clock in the format hh/mm. If
the hours or minutes are "9" or less
then key in a leading zero. For
example: six minutes past seven in
the morning will be "07:06".
11. Press .
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
The control unit saves you changes
and the display returns to the date
and time menu option.
Note: The internal clock adjusts itself for daylight saving in Spring and
Autumn.

Programming Outputs

During programming the installer may allocate some outputs so that they
can be reprogrammed by an Master User. This section describes how the
Master User can use those outputs.
For each output you can, if you wish, set an "on" time and an "off" time so
that the output will go on and off at fixed times each day. In addition,
Master and Normal users can switch the output on or off at any time.
To program an output:
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Page 64












i-on16