Section 6. Replacement Procedures; Overview - SATO e Series Service Manual

Replacement Procedures

6.1 Overview

The SATO M-10e Printer contains replaceable components and subassemblies. This section
contains step-by-step instructions for removing and replacing the following components and
sub-assemblies.
• Print Head
• Timing Belt
• Platen Roller
• Feed Roller
• LC /Keyboard PCB
• Main Circuit Board
• Interface PCB
• Power Supply
• Stepper Motor
• Fuses
• EEPROM
• Ribbon PCB
• Pitch Sensors
• Label Penetrating Sensor
• Ribbon Sensor
• Cutter Unit
Procedures in this section require standard metric tools.
Other equipment is listed where required.
SATO M-10e TT/DT Printers Service Manual
Section
6
PN 9001098
Rev. A
6-1