Setting The Dip Switch - SATO CT4-ex-RF Operator's Manual

Setting the DIP Switch

The DIP switches inside the front cover are important for selecting among the
functions of the printer.
If the setting of the DIP switch is not correct, the printer does not work correctly. If
you need to set the DIP switches, try to understand the functions of the printer
well before setting.
Setting List of the DIP Switch
Print mode
Continuous
Cutter
Partial cut
Interface
USB
LAN
RS-232C
Key-Bo
• Partial cut is the cutting function to cut the media and leave a part of it intact. There
are notes to use it. For details, contact your SATO reseller or technical support
center.
• The head check is just for a reference to check a broken element of the print head,
and it is not a function to guarantee barcode readability. Check readability regularly.
(When a void of printing goes up, the head check function may not work at the same
time).
• You can use the USB connector without reference to the setting of the DIP switch.
30
SW1 SW2 SW3
OFF OFF OFF
OFF ON OFF
ON ON
SW7 SW8
- -
OFF OFF
OFF ON
ON ON
Print Method
Thermal transfer
Direct thermal
ON
Head Check
Enabled
Disabled
Selection of VR1
adjustment
Adjustment of print
darkness
Adjustment of offset
SW4
ON
OFF
SW5
ON
OFF
SW6
ON
OFF