Reverse Image - SATO M8485Se Programming Reference Manual

REVERSE IMAGE

FUNCTION
To reverse an image area from black to white and vice versa. Use the Print Position
commands (<ESC>H and <ESC>V) to locate the top left corner of the reverse image area.
FORMAT
<ESC>(aaaa,bbbb
Must be preceded by all other data and be placed just before <ESC>Q.
EXAMPLE
<ESC>A
<ESC>H0050<ESC>V0120<ESC>L0202<ESC>WB1REVERSE
<ESC>H0250<ESC>V0300<ESC>L0202<ESC>WB1HALF
<ESC>H0040<ESC>V0110<ESC>(370,100
<ESC>H0240<ESC>V0290<ESC>(220,47
<ESC>Q1
<ESC>Z
OUTPUT
(4-8)
NOTES
A reverse image area is affected by the rotate commands. Therefore, always assume the printer is in
the normal print orientation when designing and sending the Reverse Image command.
If using reverse images with the form overlay, place this command before the Form Overlay command
in the data stream.
If the height and width to be reversed contains anything other than alphanumeric data, the area is not
printed.
If the values specified exceed the maximum ranges, the reverse image is not created.
E/Pro Programming Reference
Unit 4: Standard Command Codes
a = Horizontal length in dots of reverse image area
b = Vertical height in dots of reverse image area.
4-12
PN: 9001096B