Change Password - SATO CL4NX Operator's Manual

Change Password

System > Password > Change Password
Change the password.
You can enter 4 to 32 characters including alphabet (capital and small
letters), numbers and symbols.
The setting items are as follows:
• admin: This is the setting item for factory.
Strictly for SATO authorized personnel use.
• manager: The password for accessing the Service menu.
Strictly for SATO authorized personnel use.
• level1: The password for accessing the Settings menu.
• rfid: This is the setting item for factory.
Strictly for SATO authorized personnel use.
Note
The admin, manager and rfid passwords are for factory and maintenance
personnel. You cannot change these passwords.
Start on AC
System > Start on AC
Set whether to power on/off the printer by powering on/off the main power
source.
The options are as follows:
• Enabled: Power on/off the printer by powering on/off the main power
source.
• Disabled: Power on/off the printer by pressing the
the printer.
CAUTION
• Do not repeatedly power on and off the printer.
• If you power the main power source off and then on again quickly, the
printer may not be powered on because it is still in the powering off
process. In such a case, press the
printer.
• Do not power off the printer during operation, such as when printing or
updating. Doing so could cause a malfunction of the printer.
• Do not disconnect the power cord until the powering off process is
completed on the printer.
• An incorrect power on/off operation may damage the printer settings. In
such a case, the printer settings are reset to their default values.
power button of
power button to power on the
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
215