Suzuki 2006 SX4 Service Manual page 1419

Terminal Circuit
Driver side door lock
L01-10 actuator control (Unlock) (if
equipped)
Rear end door opener
L01-11
actuator control (if equipped)
Manual door lock switch
L01-12
(Lock) (if equipped)
L01-13 —
L01-14 Driver side seat belt switch
Door switch (other than
L01-15 driver side door and rear end
door)
Driver side door key cylinder
L01-16
switch (Lock) (if equipped)
Driver side door key cylinder
L01-17
switch (Unlock) (if equipped)
L01-18 —
BCM connector "E04"
Terminal Circuit
CAN communication line (high)
E04-1
for ABS control module
CAN communication line (low)
E04-2
for ABS control module
E04-3
E04-4 Generator "L" terminal
E04-5 Brake fluid level switch
E04-6
E04-7
Sensor ground for outside air
E04-8 temperature sensor (if
equipped)
Serial communication line of
E04-9 data link connector for ABS
control module
Outside air temperature sensor
E04-10
(if equipped)
E04-11 Oil pressure switch
E04-12
Normal voltage
10 – 14 V
0 V
0 V
10 – 14 V
10 – 14 V
0 V
—
*0 – 3 V
↑↓
10 – 14 V
0 V
10 – 14 V
0 V
10 – 14 V
0 V
10 – 14 V
0 V
—
Normal voltage
*2.5 – 3.6 V
*1.6 – 2.5 V
—
10 – 14 V
*0 – 3 V
10 – 14 V
—
—
7 – 12 V
About 1.5 V
*3 – 14 V
—
Body Electrical Control System:
Unlock signal is output for driver side door
lock actuator
Unlock signal is not output for driver side
door lock actuator
Rear end door actuator motor is not in
operation
Rear end door actuator motor is in operation
Manual door lock switch is at any position
other than lock position
Manual door lock switch is at lock position
Refer to "Reference waveform No. 2: "
Ignition switch is at ON position and driver
side seat belt is unfastened
Rear right and left side door and passenger
side door are closed
Any one of the door is opened (except driver
side door and rear end door)
Driver side door key cylinder switch is at any
position other than lock position
Driver side door key cylinder switch is at lock
position
Driver side door key cylinder switch is at any
position other than unlock position
Driver side door key cylinder switch is at
unlock position
Refer to "Reference waveform No. 3: "
—
Engine is running
0 V Ignition switch is at ON position
↑↓
Refer to "Reference waveform No. 1: "
Ignition switch is at ON position, parking brake
0 V lever is released and brake fluid level is lower
than MIN level
—
—
0 V
Ignition switch is at ON position
Ignition switch is at ON position and outside
air temperature approx. 20 °C (68 °F)
Refer to "Reference waveform No. 4: "
Ignition switch is at ON position and engine is
0 V
at stop
—
Condition
—
—
Condition
—
—
—
—
—
10B-20