Suzuki 2006 SX4 Service Manual page 1461

Reference waveform No. 2
Center antenna signal
(Request signal (1) transmitted by center antenna when
each door request switch is pushed)
Measurement CH1: "G16-6" to "G16-9"
terminal CH2: "G16-5" to "G16-9"
Oscilloscope setting CH1: 10 V/DIV, CH2: 2 V/DIV
TIME: 20 ms/DIV
Measurement • Ignition knob switch of steering
condition
• Request switch of each door is
Reference waveform No. 3
Luggage room antenna signal
(Request signal (1) transmitted by luggage room
antenna when each door request switch is pushed)
Measurement CH1: "G16-8" to "G16-9"
terminal CH2: "G16-7" to "G16-9"
Oscilloscope setting CH1: 10 V/DIV, CH2: 10 V/DIV
TIME: 20 ms/DIV
Measurement Request switch of each door is
condition pushed with remote controller
carried
lock unit is pushed
pushed with remote controller
carried
I5JB0AA50024-03
I5JB0AA50025-02
Keyless Start System:
Reference waveform No. 4
CAN communication signals
(CAN signal communicated to each control module
when ignition switch is turned ON)
Measurement CH1: "G16-19" to "G16-9"
terminal CH2: "G16-18" to "G16-9"
Oscilloscope setting CH1: 1 V/DIV, CH2: 1 V/DIV
TIME: 40 µs/DIV
Measurement
Ignition switch is at ON position
condition
1. CAN communication line signal (high)
2. CAN communication line signal (low)
Reference waveform No. 5
Steering lock unit signal
(Signal (1) communicated between keyless start control
module and steering lock unit when measurement
condition described below applies)
Measurement
CH1: "G16-29" to "G16-9"
terminal
Oscilloscope setting CH1: 2 V/DIV
TIME: 4 ms/DIV
Measurement • Ignition knob switch of steering
condition
• Any one of door is opened
• Request switch of each door is
10E-17
I5RS0DA50002-01
lock unit is pushed
pushed
I4RS0BA50019-02