BCM Reception Data
BCM
Receive
Theft Deterrent Light
The information display or clock (1) of this vehicle includes a theft deterrent light (2) for the theft preventive purpose.
The BCM makes the theft deterrent light flash at certain intervals after the ignition switch is turned off until it is turned
on again. Also, DTCs stored in BCM can be checked by reading the flashing patterns of the theft deterrent light when
diagnosing troubles.
Body Electrical Control System Wiring Circuit Diagram
NOTE
This wiring diagram shows circuits related to only BCM, not the entire circuits of BCM and junction
block. Refer to "Power Supply Diagram in Section 9A" for wiring circuits other than the figure below.
Engine speed signal
Engine coolant temperature signal
Vehicle speed signal
Brake pedal switch signal
A/C compressor clutch signal
A/C refrigerant pressure signal
Fuel consumption signal
DATA
Engine type signal
Transmission range sensor signal
Combination meter spec signal
Ignition knob switch signal
Door lock/unlock request signal
Buzzer request signal
Answer back request signal
1
Schematic and Routing Diagram
Body Electrical Control System:
TCM
Combination
ECM
(A/T model)
Meter
2
I5RW0AA20003-01
10B-2
Keyless Start
Control Module
(if equipped)
I6RW0CA20002-01
S6RW0CA201003
S6RW0CA202001