Shift Motor - Canon Finisher-AB1 Service Manual

3) Remove the screw [1], and open the connector
cover [2] in the direction of the arrow.
F-4-49
4) Disconnect the connector [1], and free the cable
[4] from the edge saddle [2] and the wire saddle
[3].
[3] [2]
F-4-50
5) Remove the tray A/B lift motor.
- 2 screws [2]
- 1 belt [3]
[3]
F-4-51
[1] [2]
[4] [1]
[2]

4.3.6 Shift Motor

4.3.6.1 Before Removing the Shift Motor
1) Disconnect the machine from the host machine
side.
2) Remove the upper rear cover (right). (page 4-
2)Reference[Removing the Upper Rear Cover
(right)]
3) Remove the upper rear cover (left). (page 4-
3)Reference[Removing the Upper Rear Cover
(left)]
4) Remove the middle rear cover. (page 4-
7)Reference[Removing the Middle Rear Cover]
5) Remove the upper cover unit. (page 4-
3)Reference[Removing the Upper Cover Unit]
6) Remove the inside cover (upper). (page 4-
7)Reference[Removing the Inside Cover (upper)]
4.3.6.2 Removing the Shift Motor
1) Remove the latch base support plate [1].
- 2 screws [2]
[1]
[1]
Chapter 4
[2]
F-4-52
0015-2305
0015-2306
4-13