Tray Shift Motor - Canon Finisher-AB1 Service Manual

Table of Contents

Advertisement

7) Remove the aligning motor (rear) [1].
(page 5-11)Reference[Adjusting the Angle of
the Aligning Plate (orthogonal)]
(page 5-13)Reference[Adjusting the Aligning
Plate Width]
- 1 clamp [2]
- 2 cable guides [3]
- 1 connector [4]
- 2 screws [5]
[3]
[1]
[5]

4.3.4 Tray Shift Motor

4.3.4.1 Removing the Tray A/B Lift Motor
1)Remove the tray A/B cover [1].
- 4 screws [2]
[1]
[2]
[4]
F-4-41
[2]
F-4-42
2) While supporting the tray from below, release the
roll [1] in the direction of the arrow; then, move it
down until it stops.
[1]
3) Remove the screw [1], and open the connector
cover [2] in the direction of the arrow.
0015-2304
4) Disconnect the connector [1], and free the cable
[4] from the edge saddle [2] and the wire saddle
[3].
[3]
Chapter 4
F-4-43
[1]
F-4-44
[2]
[4]
[1]
F-4-45
[2]
4-11

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Saddle finisher-ab2

Table of Contents