Bufferless Mode 1 - Canon Finisher-AB1 Service Manual

5) Set the DIP SW382 [1] on the Switch PCB as
shown in the figure below. EEPROM is
initialized by pressing the switches in the order of
SW385,SW384,SW383, once for each.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-119
6) Make the following adjustments:
- Sensor light intensity adjustment
- Swing guide speed adjustment
- Alignment plate width adjustment
- Staple position adjustment (1-point binding at
the rear)
- Staple position adjustment (1-point binding at
the front)
- Staple position adjustment (2-point binding)
- Stapled stack delivery adjustment (lower
delivery)
- Stapled stack delivery adjustment (saddle
delivery)
- Feed belt position adjustment
- Saddle leading edge stopper position adjustment
- Saddle binding position adjustment
- Saddle folding position adjustment
- Punch hole position
registration direction)
- Punch hole position adjustment (feed direction)

- Bufferless mode 1

- Bufferless mode 2
- Staple inlet guide height adjustment
- Paddle height adjustment
- Adjustment at poor tray stackability (when the
upper curl occurs)
- Adjustment at poor tray stackability (when the
lower curl occurs)
- Adjustment at poor tray stackability (run over
when using thin paper)
- Tray stacking limit cancellation adjustment
5.3.2.17 Bufferless mode 1
This mode is selected when the conditions listed
below are satisfied.
- When poor alignment has occurred in cases where
a multiple number of copies has been made
- When the corners of the sheets are creased
- When a buffer path 2 sensor stationary jam (jam
adjustment (side
0016-4794
code: 1109) has occurred
- When the EEPROM (IC107) on the finisher
controller PCB has been replaced
When this mode is selected, the buffer operation is
not performed regardless of the loading method
(non-staple loading or staple loading).
The procedure for establishing the settings in this
mode is described below.
1) Turn on the finisher.
2) Turn on the host machine so that the machine will
be in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-120
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-121
Chapter 5
[1]
5-39
[1]