Adjusting The Stapling Position (Rear 1-Point) - Canon Finisher-AB1 Service Manual

Reference:
1. If wear has occurred on the transport belt or
recycled paper (i.e., with high surface resistance)
is used, select a negative adjustment value (-1 to -
4) to increase the retention.
2. If dents have occurred in the edge of paper,
select a positive adjustment value (+1 to +4) to
decrease the retention.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
[5]
F-5-49
8) Press the push switch SW385 [1] to end
adjustment of the transport belt.
If the LED [2] indicates '0', the adjustment has
ended successfully.
[3]
[4]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-50
9) If the LED indicates '0', on the other hand, the
adjustment has failed. Repeat the foregoing steps.
5.3.2.7 Adjusting the Stapling Position
(rear 1-point)
Go through the following steps if there is
displacement in the stapling position (rear 1-point)
or if you have replaced the EEPROM of the finisher
controller PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-51
Chapter 5
[2]
[1]
0015-2232
[1]
5-17