Tray Stacking Limit Cancellation Adjustment - Canon Finisher-AB1 Service Manual

8) This adjustment is completed when the push
switch SW385 [1] is pressed again.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-136
5.3.2.20 Tray stacking limit cancellation
adjustment
This adjustment is performed either when canceling
the tray stacking limit for coated paper and extra long
paper or when replacing the EEPROM (IC107) on
the finisher controller PCB.
[B]
[A]
F-5-137
[1] Loading under normal conditions
[2] Loading when the stacking limit is cancelled
<Memo>
This adjustment works for the upper tray only. The
stacking limit of the lower tray cannot be cancelled.
The table below shows the loading capacity of the
lower tray when the stacking limit has been
cancelled.
Paper type
Plain paper
(extra long
size)
Coated
paper (half
size)
Coated
paper (large
size)
[1]
Details of the adjustment procedure are provided
below.
1) Turn on the finisher.
2) Turn on the host machine so that the machine will
be in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
0016-6232
Chapter 5
T-5-6
Loading capacity
Under normal When the stacking
conditions limit is cancelled
1,000 sheets 1,500 sheets
1,500 sheets 3,000 sheets
1,000 sheets 1,500 sheets
F-5-138
[1]
5-41