E510 (Inlet Motor M1 Fault); E514; E530 (Rear Aligning Plate Motor M5); E531 (Stapler Motor M11) - Canon SADDLE FINISHER K3 Service Manual

CHAPTER 5 TROUBLESHOOTING
E510
Main cause Inlet motor (M1)
Detection The clocks from the inlet motor is 50 mm/sec or less for 1 sec or more
while the motor is in operation.

E514

Main cause Stack delivery motor (M7)
Stack motor clock sensor (PI12)
Front aligning plate motor (M4)
Detection The clocks from the stack delivery motor clock sensor is 50 mm/sc or less
for 1 sec or more when the motor is in operation.
E537
Main cause Front aligning plate motor (M4)
Front aligning plate home position sensor (PI7)
Detection The front aligning plate does not leave the front aligning plate home posi-
tion sensor when the front aligning plate motor is driven for 4 sec.
The front aligning plate does not return to front aligning plate home posi-
tion sensor when the front aligning plate motor is driven for 4 sec.
E530
Main cause Rear aligning plate motor (M5)
Rear aligning plate home position sensor (PI9)
Detection The rear aligning plate does not leave rear aligning plate home position sen-
sor when the rear aligning plate motor is driven for 4 sec.
The rear aligning plate does not return to rear aligning plate home position
sensor when the rear aligning plate motor is driven for 4 sec.
E531
Main cause Stapler motor (M6)
Stapler home position detecting switch (inside stapler)
Detection The stapler does not leave stapler home position when the stapler motor is
driven or 0. 5 sec.
The stapler does not return to stapler home position when the stapler motor
is driven for 0.5 sec.
E532
Main cause Stapler shift motor (M10)
Stapler shift home position sensor (P16)
Detection The stapler shift home position sensor does not go OFF when the stapler
shift motor is driven for 4 sec.
The stapler shift home position is not detected when the stapler shift motor
is driven for 4 sec.
5-100
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001