Canon Finisher-AB1 Service Manual page 448

Code Detail Occurrence
code classification
- Occurrence classification
02: Finisher (including inserter, puncher, trimmer)
11: POD deck 12: Secondary POD deck
51: Stacker 52: Secondary stacker
- When turning ON the power, be sure to turn ON the power in the following order: pickup/delivery accessories ->
Main Body: Otherwise the pickup/delivery accessories are not recognized.
E583 Bundle delivery auxiliary tray operation malfunction
8001 02
8002 02
Shutter malfunction
E584
8001 02
8002 02
E5F0
8001 02
(Saddle)
8002
8010 51, 52
Saddle folding malfunction
E5F1
8001 02
(Saddle)
Description
Bundle delivery auxiliary tray HP
sensor does not come ON within 5
sec. after bundle delivery auxiliary
tray motor operation begins.
Bundle delivery auxiliary tray HP
sensor does not go OFF within 5 sec.
after bundle delivery auxiliary tray
motor operation begins.
Shutter HP sensor does not come ON
within 5 sec. after paddle rotation
motor operation begins.
Shutter HP sensor does not go OFF
within 5 sec. after paddle rotation
motor operation begins.
Saddle positioning plate malfunction
Stopper HP sensor does not come
ON within 5 sec. after stopper motor
operation begins.
Stopper HP sensor does not go OFF
within 5 sec. after stopper motor
operation begins.
Stack tray overflow
Fold/ feed motor rotation detection
sensor does not come ON within 5
sec. after fold/ feed motor operation
begins.
Treatment/ detection timing
-Check bundle delivery auxiliary tray motor and
bundle delivery auxiliary tray HP sensor connectors
bundle delivery auxiliary tray motor
-Replace bundle delivery auxiliary tray motor and
bundle delivery auxiliary tray HP sensor.
-Check bundle delivery auxiliary tray motor and
bundle delivery auxiliary tray HP sensor connectors
bundle delivery auxiliary tray motor
-Replace bundle delivery auxiliary tray motor and
bundle delivery auxiliary tray HP sensor.
-Check paddle rotation motor and shutter HP sensor
connectors.
-Replace paddle rotation motor and shutter HP sensor
connectors.
-Replace the finisher controller PCB.
-Check paddle rotation motor and shutter HP sensor
connectors.
-Replace paddle rotation motor and shutter HP sensor
connectors.
-Replace the finisher controller PCB.
- Check stopper motor and stopper HP sensor
connectors.
- Replace stopper motor and stopper HP sensor.
-Replace saddle stitcher controller PCB.
- Check stopper motor and stopper HP sensor
connectors.
- Replace stopper motor and stopper HP sensor.
-Replace saddle stitcher controller PCB.
Stack tray overflow
The tray lower dead center sensor is activated during
the stack delivery.
-Check fold/ feed motor and fold/ feed motor rotation
detection sensor connectors.
-Replace fold/ feed motor and fold/ feed motor
rotation detection sensor.
-Replace saddle stitcher controller PCB.
Chapter 6
6-9