Canon Finisher-AB1 Service Manual page 139

5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-103
6) The preparations for the staple inlet guide height
adjustment are completed by pressing the push
switch (SW385) [1].
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-104
7) The adjustment amount is determined by pressing
either one of the push switches: SW383 [1] or
SW384 [2].
When SW383 is pressed once, "-1" appears on the
LED [3], and the staple inelt guide height position
[4] is lowered.
On the other hand, when SW384 is pressed once,
"+1" appears on the LED [3], and the staple inlet
guide height position [5] is raised.
Adjustment range: +4 to -4 (Each 1 setting value
change results in the movement of 0.5mm.)
<Reference>
When the foregoing fault has occurred, it can be
remedied by changing the adjustment value in the
negative direction.
[1]
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[2]
F-5-105
[4]
F-5-106
Chapter 5
[3]
[5]
5-33