Paddle Height Adjustment - Canon Finisher-AB1 Service Manual

Chapter 5
F-5-137
8) This adjustment is completed by pressing the push
switch SW385 [1] again.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-138

5.3.2.21 Paddle height adjustment

This adjustment is performed either when poor tray
stacking occurs with thin papers shown in the figure
below or when the EEPROM (IC107) on the finisher
controller PCB is replaced.
6) The preparations for the paddle height adjustment
are completed by pressing the push switch SW385
[1].
5-44
[4]
[1]
0016-6224
F-5-139
1) Turn on the finisher.
2) Turn on the host machine so that the machine will
be in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-140
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-141
[1]
[1]