Adjusting The Stapling Position (Rear 1-Point); Adjusting The Stapling Position (Front 1-Point) - Canon Finisher-AB1 Service Manual

8) Press the push switch SW385 [1] to end
adjustment of the transport belt.
If the LED [2] indicates '0', the adjustment has
ended successfully.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-50
9) If the LED indicates '0', on the other hand, the
adjustment has failed. Repeat the foregoing steps.
5.3.2.7 Adjusting the Stapling Position
(rear 1-point)
Go through the following steps if there is
displacement in the stapling position (rear 1-point)
or if you have replaced the EEPROM of the finisher
controller PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-51
[2]
[1]
0015-2232
[1]
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-52
5) Set the DIP switch SW382 [1] of the switch PCB
as follows:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-53
Chapter 5
[1]
5-19