Removing The Side Registration Shift Motor - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Feed Assembly > Removing the Side Registration Shift Motor > Procedure

Removing the Side Registration Shift Motor

■ Preparation
1) Open the Front Cover.
2) Separate the finisher from the host machine.(Refer to page 4-18)
3) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
4) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Remove the Inner Cover (Upper).(Refer to page 4-22)
7) Remove the Side Registration Shift Unit.(Refer to page 4-49)
■ Procedure
1) Move the Shift Motor Unit [1].
• 5 Screws [2]
4 Parts Replacing and Cleaning > Feed Assembly > Removing the Side Registration Shift Motor > Procedure
[2]
[1]
[2]
[2]
F-4-115
2) Remove the Shift Motor Unit [1].
• 1 Screw [2]
• Flat Cable Retainer Plate [3]
• 1 Connector [4]
[3] [4]
[2]
CAUTION:
When installing/removing the Shift Motor Unit, be sure to fit the screw [2] of the Belt
Retainer Assembly [1] to the dent [A] of the Mounting Plate.
4-53
[1]
F-4-116
[1] [A]
[2]
F-4-117
4-53