Adjusting The Stapling Position (2-Point) - Canon Finisher-AB1 Service Manual

Chapter 5
10) Check to make sure that the stapling position is 5
+/-2 mm [1] as a result of the foregoing steps.
Otherwise, go back to step 6).
F-5-68
If the LED indicates other than '0', the adjustment is
likely to have failed. Start over.
5-22
5.3.2.9 Adjusting the Stapling Position (2-
point)
Go through the following steps if there is
[1]
displacement in stapling position (2-point) or if you
have replaced the EEPROM of the finisher controller
PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
4) Remove the screw [2], and detach the switch
cover [1].
F-5-69
[1]
[2]
F-5-70
0015-2237
[1]