Canon Finisher-AB1 Service Manual page 450

Code Detail Occurrence
code classification
- Occurrence classification
02: Finisher (including inserter, puncher, trimmer)
11: POD deck 12: Secondary POD deck
51: Stacker 52: Secondary stacker
- When turning ON the power, be sure to turn ON the power in the following order: pickup/delivery accessories ->
Main Body: Otherwise the pickup/delivery accessories are not recognized.
E5FA Saddle press malfunction
8000 02
8001 02
8002 02
Saddle disengage operation malfunction
E5FB
8001 02
8002 02
Description
Saddle press position sensor does not
come ON within 200ms. after saddle
press motor operation begins.
Saddle press HP sensor does not
come ON within 1 sec. after saddle
press motor operation begins.
Saddle press HP sensor does not go
OFF within 1 sec. after saddle press
motor operation begins.
Saddle pull-in roller HP sensor does
not come ON within 3 sec. after
saddle pull-in roller disengage motor
operation begins.
Saddle pull-in roller HP sensor does
not go OFF within 3 sec. after saddle
pull-in roller disengage motor
operation begins.
Treatment/ detection timing
-Check saddle press motor and saddle press position
sensor connectors.
-Replace saddle press motor and saddle press position
sensor.
-Replace stitcher controller PCB.
-Check saddle press motor and saddle press HP sensor
connectors.
-Replace saddle press motor and saddle press HP
sensor.
-Replace stitcher controller PCB.
-Check saddle press motor and saddle press HP sensor
connectors.
-Replace saddle press motor and saddle press HP
sensor.
-Replace stitcher controller PCB.
-Check saddle pull-in roller and saddle pull-in roller
HP sensor connectors.
-Replace saddle pull-in roller and saddle pull-in roller
HP sensor.
-Replace stitcher controller PCB.
-Check saddle pull-in roller and saddle pull-in roller
HP sensor connectors.
-Replace saddle pull-in roller and saddle pull-in roller
HP sensor.
-Replace stitcher controller PCB.
Chapter 6
6-11