Horizontal Registration Sensor Unit - Canon Finisher-AB1 Service Manual

Chapter 4
4) Remove the flapper static eliminator [1].
- 3 screws [2]
[1]
[2]
F-4-194
Points to Note When Mounting the Static
Eliminator
Be sure to put the tip [1] of the static eliminator into
the hole [2] of the plate before fitting it in place.
[2]
[1]
F-4-195
4-50
4.5.3 Horizontal Registration Sensor
Unit
4.5.3.1 Before Removing the Horizontal
Registration Sensor Unit
1) Separate the machine from the host machine side.
(page 4-1)Reference[Disconnecting from the
Host Machine]
2) Remove the upper rear cover (right). (page 4-
2)Reference[Removing the Upper Rear Cover
(right)]
3) Remove the upper rear cover (left). (page 4-
3)Reference[Removing the Upper Rear Cover
(left)]
4) Remove the middle rear cover.
5) Remove the upper cover unit. (page 4-
3)Reference[Removing the Upper Cover Unit]
6) Remove the middle rear cover. (page 4-
7)Reference[Removing the Middle Rear Cover]
4.5.3.2 Removing the Horizontal
Registration Sensor Unit
1) Remove the fan unit [1].
- 1 connector [2]
- 2 screws [3]
[3]
F-4-196
0015-2205
0015-2206
[2]
[1]