Canon Finisher-AB1 Service Manual page 353

3) In the case of the Finisher-AB1, remove the caster
cover [1].
- 1 screw [2]
4) In the case of the Saddle Finbserh-AB2, detach the
saddle inside cover (lower) [1].
- 1 screw [2]
- 1 knob [3]
- 3 screws [4]
[4]
[2] [3]
5) Remove the 2 caster covers [1] from the left side.
(The illustration shows the saddle finisher.)
- 2 screws [2]
[2]
F-5-4
[4]
F-5-5
[1]
[2]
6) Measure the height [A] from the caster mounted
surface to the upper surface of bottom plate using
a scale or the like and check if the height is 84.6
+/- 0.5 mm.
[1]
Chapter 5
[1]
F-5-6
[A]
84.6 0.5mm
F-5-7
5-5