Canon Finisher-AB1 Service Manual page 305

4.3.4.2 Removing the Alignment Motor
(rear)
1) Free the cable [2] from the 3 clamps, and
disconnect the connector [3].
[2]
F-4-40
2) Free the cable [2] connected to the 2 clamps [1],
and disconnect the connector [3].
F-4-41
3) Remove the handling plate unit [1].
- 1 screw [2] (loosen)
- 1 screw [3]
- 6 screws [4]
- 2 positioning plates [5]
0015-2303
[1]
[4] [5]
[3]
4) Remove the handling tray aligning plate (rear).
- 1 screw [2]
[2]
- 1 claw [3]
[2]
[1]
[3]
5) Remove the handling tray (front) [1].
- 2 screws [2]
[4] [3] [5]
[2]
[4]
[1]
F-4-42
[1] [3]
F-4-43
[2] [1]
F-4-44
Chapter 4
[4]
4-11