Canon Finisher-AB1 Service Manual page 161

DIP setting
SW382
SW382
SW382
SW382
SW382
Item
checking the sensors 2
adjusting the tray A width
(A4)
adjusting the tray B width
(A4)
adjusting the tray A width
(LTR)
adjusting the tray B width
(LTR)
Description
Press ENTER to start. A press on +/- switches over
sensors. Press ENTER to end.
1. feed sensor
2. not used
3. feed sensor 2
4. tray A lower limit sensor
5. tray B lower limit sensor
6. drive switchover sensor
7. not used
8. upper cover open/closed sensor
9. inserter open/closed sensor
A press on the + switch moves the sensor in question.
The sensor in question is indicated on the display
(DSP381).
1) Set the DIP switch to suit the tray being adjusted and
the paper configuration.
2) Press ENTER.
3) Place A4 or LTR paper in the upper or lower tray.
(minimum width adjustment)
4) Press the + switch.
5) $
6) Press the - switch.
7) Press ENTER to end.
Chapter 5
5-55