Canon Finisher-AB1 Service Manual page 412

Chapter 5
DIP setting
SW382
SW382
SW382
SW382
SW382
SW382
SW382
SW382
5-64
Item
driving the drive switchover motor Press ENTER to start. A press on + will start tray A,
driving tray pickup motor
driving the feed motor
driving the tray A lift motor
driving the tray B lift motor
driving the tray registration clutch Press ENTER to start. It will stop automatically.
Ageing
checking the sensors 1
T-5-9
Description
while a press on - will start tray B. Press ENTER to
end.
Press ENTER to start. A press on +/- will switch
over the speed (250, 500, 1100 mm/sec). Press
ENTER to end.
Press ENTER to start (1100 mm/sec). Press ENTER
to end.
Press ENTER to start (1100 mms/sec). Press
ENTER to end.
(ON for 500 msec)
Press ENTER to start and repeat the following
operations; press ENTER to end:
tray A up>50 sheets in tray A>tray A down>tray B
up>50 sheets in tray B>tray B down
Press ENTER to start. A press on +/- switches over
sensors. Press ENTER to end.
1. tray A paper placement sensor
2. tray A pickup sensor
3. tray A registration sensor
4. tray A paper sensor
5. tray B paper sensor 1
6. tray B paper sensor 2
7. tray B paper placement sensor
8. tray B pickup sensor
9. tray B registration sensor
A press on the + switch to start the sensor in
question. The sensor in question is indicated on the
display (DSP381). If the sensor operation is normal,
1 goes on in response to the placement of paper,
while it flashes when the paper is removed.