Thrust Plate - Canon Finisher-AB1 Service Manual

Chapter 4
4) Disconnect the 11 connector [1], and detach the
cable from the guide.
[1]
F-4-138
5) Disconnect the 2 connectors [1], and free the cable
from the 3 clamps [2] and the 3 edge saddles [3].
[3]
[2]
F-4-139
6) Remove the 2 clamps [1], and disconnect the
connector [2].
F-4-140
4-36
[1]
[1]
[3]
[2]
[1]
[3]
[2]
[2]
[1]
7) Remove the stop unit [1].
- 4 screws [2]
[2]
F-4-141

4.4.13 Thrust Plate

4.4.13.1 Before Removing the Stop Plate
1) Remove the
35)Reference[Removing the Stop Unit]
4.4.13.2 Removing the Stop Plate
1) Turn the gear [1] in the direction of the arrow [A]
so that the stop plate [2] is extended as far as
possible.
[2]
[A]
[1]
F-4-142
[1]
stop unit. (page
[2]
0015-2184
4-
0015-2185