Adjustment At Poor Tray Stackability (Run Over When Using Thin Paper) - Canon Finisher-AB1 Service Manual

7) When the push switch SW384 [1] is pressed twice,
"+2" appears on the LED [2].
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-128
8) This adjustment is completed when the push
switch SW385 [1] is pressed again.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-129
5.3.2.19 Adjustment at poor tray
stackability (run over when using thin
paper)
This adjustment is performed either when poor tray
stackability occurs with thin papers shown in the
figure below or when the EEPROM (IC107) on the
finisher controller PCB is replaced.
[2]
[1]
0016-6230
F-5-130
<Memo>
By executing this adjustment, the finisher reduces
the feeding speed. As a result, the degree of curl of
thin paper is reduced; thus, the poor tray stackability
mentioned above is reduced.
Details of the adjustment procedure are provided
below.
1) Turn on the finisher.
2) Turn on the host machine so that the machine will
be in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-131
Chapter 5
[1]
5-39