Adjustment; Basic Adjustment; Adjusting The Height - Canon Finisher-AB1 Service Manual

5.3 Adjustment

5.3.1 Basic Adjustment

5.3.1.1 Adjusting the Height

If jams start to occur often, adjust the height of the
machine as follows:
1. Checking the Height
1) Check the height of the finisher and the host
machine. Be sure that the difference in height
between the right top surface [1] of the finisher
and the left top surface [2] of the host machine is
+/-2 mm.
[1]
2) If the difference is +/-2 mm or more, adjust the
height.
In order to adjusting the height, adjust four casters
[1] shown in the figure.
[2]
F-5-1
0015-2219
[1]

2. Adjusting the Height

1) Disconnect the finisher from the host machine.
2) Detach the spanner [1] connected to the front
cover.
- 1 screw [2]
[1]
[2]
Chapter 5
F-5-2
F-5-3
[1]
5-3