Canon Finisher-AB1 Service Manual page 443

Chapter 6
Code Detail Occurrence
code classification
- Occurrence classification
02: Finisher (including inserter, puncher, trimmer)
11: POD deck 12: Secondary POD deck
51: Stacker 52: Secondary stacker
- When turning ON the power, be sure to turn ON the power in the following order: pickup/delivery accessories ->
Main Body: Otherwise the pickup/delivery accessories are not recognized.
E515 8007
(cont
inue)
8010 51, 52
Rear alignment malfunction
E530
8001 02
8002 02
Staple malfunction
E531
8001 02
8002 02
Staple slide malfunction
E532
8001 02
6-4
Description
Improper value detected for tray A
width detection sensor or tray B
width detection sensor.
Offset Section DriveMotor M07
Alarm
Rear alignment HP sensor does not
come on after the rear alignment
motor has been running for 5 sec.
Rear alignment sensor does not go
OFF within 1 sec. of rear alignment
motor operation starting.
Staple position HP sensor does not
come ON within 500 msec. after
staple motor operation begins.
Staple HP sensor does not go OFF
within 500 msec. after staple motor
operation begins.
Staple HP sensor does not come ON
within 500 msec. after staple shift
motor operation begins.
Treatment/ detection timing
Adjust tray width.
An alarm has occurred on the offset section drive
motor driver PCB A07.
- Check rear alignment HP sensor connectors.
- Check rear alignment motor connectors.
- Replace rear alignment HP sensor.
- Replace rear alignment motor.
- Replace finisher controller.
- Check rear alignment HP sensor connectors.
- Check rear alignment motor connectors.
- Replace rear alignment HP sensor.
- Replace rear alignment motor.
- Replace finisher controller.
- Check the staple unit connectors.
- Replace the staple unit.
- Check the staple unit HP sensor connectors.
- Replace the staple unit HP sensor.
- Replace the finisher unit controller PCB.E89
- Check the staple unit connectors.
- Replace the staple unit.
- Check the staple unit HP sensor connectors.
- Replace the staple unit HP sensor.
- Replace the finisher unit controller PCB.
- Check the staple shift motor connectors.
- Replace the staple shift motor..
- Check the staple unit HP sensor connectors.
- Replace the staple unit HP sensor.
- Replace the finisher unit controller PCB.