When loosening the fixing nut on the front
caster of the saddle finisher, insert the wrench
[3] into the opening just below the saddle
bottom plate [2].
[3]
8) Rotate the adjusting bolt [1] with the wrench
(small) [2] to adjust the height in the range of
84.6+ -0.5mm.
- To increase the height: rotate in the direction of
[A]
- To lower the height: rotate in the direction of [B]
(Height change per rotation: approx. 1.75 mm)
[A]
[2]
F-2-35
[1]
[2]
[1]
[B]
9) Tighten the fixing nut [1] in the direction of [B].
[B]
F-2-36
10) Repeat the steps above to adjust the height of
other 3 casters.
11) Connect the finisher to the host machine again to
check the height.
Attach the cover and other parts removed in the
previous steps if the height difference is in the
tolerable range. If not, repeat the steps above to
readjust the height.
Chapter 2
[1]
2-13