Canon Finisher-AB1 Service Manual page 385

4) Remove the screw [2] to detach the switch cover
[1].
[2]
F-5-112
5) Set DIP SW382 [1] on the switch PCB as follows:
- if A configuration, [2]
- if L configuration, [3]
Thereafter, press SW385 to end the preparatory
work.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-113
6) Hold the lever [1], and slide out the saddle unit
[2]; then, open the saddle right guide [3].
[1]
[2]
[3]
[3]
[2]
[1]
F-5-114
7) Place paper [3] in the saddle assembly [1]. (A4R
or LTRR)
At this time, moving up the gear in area A in the
direction of the arrow releases the saddle pull-in
roller so that paper may be placed in the saddle
assembly.
[1]
F-5-115
8) Check to see that there is a gap between the saddle
guide plate and the edge of the paper. If there is,
go to the next step.
Chapter 5
[2]
[A]
5-37